Hello Guys. Let me run one by ya and see if you have encountered this before. Have my flaps Y'ed to one channel on my 955 Jr. Rx. "Aux 2" Running a 10 X Tx. When I start out with a small amount of flaps, no Problem. The more I add the worse it gets as far as the two servo's staying together. They are Hitec 5645's. Is it normal for this to happen? One servo not staying with the other. I have tried this in 3 Diff Channels and it's the same . So thats the reason I fig. it's in the servo's I know I can set-up ec servo on it's own channel and would on a higher end jet, but for now is conv to run it like it is. Thanks Guys.