RCU Forums - View Single Post - Grow Jet Parts with a 3D Printer
Thread: Grow Jet Parts with a 3D Printer
View Single Post
Old 11-13-2009 | 04:59 PM
  #12  
mr_matt's Avatar
mr_matt
My Feedback: (10)
 
Joined: Dec 2001
Posts: 10,450
Likes: 0
Received 13 Likes on 11 Posts
From: Oak Park, CA,
Default RE: Grow Jet Parts with a 3D Printer
Hi Craig,

Do you find the FDM to be able to produce the same level of detail of a straight (modern) stereo lithography setup?

The SLA would be used as a mold master, not for final parts. I want to use it for cockpit parts as well.

We have gone through 2 lasers on our big one at work and we will not get another (40K each with labor). There is so much over capacity here that it is cheaper to vend out the jobs.

Regards,
mr_matt is offline  
Reply Like