HEY THERE IM BUILDING A TOP FLITE GOLD EDITION P-47 THUNDERBOLT BEING POWERED WITH AN ASP 1.20 4 STROKE. MY QUESTION IS I CAN NOT FOR THE LIFE OF ME FIGURE OUT HOW THE 2 COWEL HALVES ARE SUPPOSED OT BE CUT AND PUT TOGETHER THE MANUAL DOSNT EXPLAIN THIS ALL TO WELL FOR ME. AND IM WONDERING IF MAYBE I HAVE A BOTCHED FORMED COWEL BECASUE AS U CAN SEE IN THE PICTURE BELOW THERE APPEARS TO BE A SUNKEN IN EDGE WITH A VERY PRONOUNCED EDGE FOR THE LITTLE COOLING VENTS BUT ON THE OTHER HAF IT IS ALMOST ENTIRLY SMOOTH. I CANT FIGURE OUT HOW WHEN I JOIN THESE TO PIECES AT THE CENTER HOW IT IS GOING TO LOOK LIKE A FULLY RAISED COOLING VENT FROM WHAT I CAN PUT TOGETHER IN MY MIND IT WILL APPEAR AS THOGH I HAVE A BUNCH OF EVEN SIZED VENTS AND THEN AT THE TOP OF THE COWEL I WILL HAVE ONE LARGER ONE AND FROM PICS I HAVE BEEN LOOKING UP IT SHOULD BE AN EVEN AMMOUNT OF EQUALLY RAISED COOLING VENTS..ALSO THAT PRONOUNCED INDENT ON THE ON HALF ON THE RIGHT HAND OF THE PIC IF U WERE TO LOOK AT A SHOT OF THE BACK THAT SAME PRONOUNCED INBDENT ID ON THE OTHER COWEL HALF BUT THEN THE OTHER ONE IS SMOOTH AGAIN. SO IF ANYONE CAN HELP ME AS TO HOW U ARE SUPPOSED TO JOIN ALL THESE PIECES PLEASE SPEAK UP BEFORE I START CUTTING AND END UP RUINING WHAT COULD BE A PERFECTLEY GOOD COWL. I ONLY HAVE ONE SHOT AT THIS AND DONT WANT TO CUT ANY WRONG STUFF!