RCU Forums - View Single Post - DX7, no trim for slave channel
Thread
:
DX7, no trim for slave channel
View Single Post
03-19-2010, 06:50 AM
#
2
airbusdrvr
Senior Member
Join Date: Nov 2005
Location: New Port Richey, FL
Posts: 2,568
Likes: 0
Received 2 Likes on
2 Posts
RE: DX7, no trim for slave channel
I'm not sure about the DX7 capability for trimming a channel mated to the elevator channel. However, when you set up your dual ailerons(probably using the flaperon function) both ailerons will trim.
Reply
Like
airbusdrvr
View Public Profile
Send a private message to airbusdrvr
Find More Posts by airbusdrvr
View iTrader Profile