RCU Forums - View Single Post - Charging LiPo Question!! (power source related)
Old 04-07-2010 | 08:28 PM
  #1  
mrzisme
Junior Member
 
Joined: Aug 2004
Posts: 14
Likes: 0
Received 0 Likes on 0 Posts
From: Toledo, OH
Default Charging LiPo Question!! (power source related)

I just purchased an E-flite apprentice and it comes with a LiPo charger with only alligator clips as a hookup. So I also purchased a rechargable Hangar9 12Volt 7Ah battery (han102) to supply the power to my LiPo Charger.

I have 2 questions.

1st. Roughly how many times I can charge my 3 cell 3200mAh 11.1V LiPo Battery using this 12Volt 7Ah battery source before the 12Volt Battery is depleted and would need recharged again?

2nd. I have a good volt meter with a lot of options. I know that if I switch it to vdc, I can get a reading off the battery to see it at about 12.77 volts. Is there a way to use a volt meter to see roughly how much capacity is remaining in the battery to know when its full, half or empty?