RCU Forums - View Single Post - Prop reamer~do I need one?
Thread: Prop reamer~do I need one?
View Single Post
Old 06-27-2010 | 01:55 PM
  #1  
krashkart
Senior Member
My Feedback: (5)
 
Joined: Nov 2009
Posts: 453
Likes: 0
Received 0 Likes on 0 Posts
From: Up in the Mountains AZ
Default Prop reamer~do I need one?


I ordered an FA-82 which shows a shaft diameter of 7mm.
I already have new APC 13x8 props in hand which are tapered from .25" to just over .30" by measurement.
7mm is about .28" as I make it.
So do I need a prop reamer?
I suppose one would be handy to have.
I don't remember doing all this 30 years ago. Maybe I did and don't remember?</p>
krashkart is offline  
Reply Like