RCU Forums - View Single Post - Trainer posibilities.
View Single Post
Old 07-31-2010 | 03:55 PM
  #3  
dem45133
Member
 
Joined: Jun 2010
Posts: 44
Likes: 0
Received 0 Likes on 0 Posts
From: , NM
Default RE: Trainer posibilities.

<font face="Comic Sans MS" size="2">This was the Saito's description on ebay...

"Up for a NO RESERVE auction is this SAITO 45 4-stroke R/C Airplane Engine. This was given to me from a friend at my local flying club, so I havecarefully taken it apart, thoroughly cleaned it, and lubricated it nicely. The engine seems to have good compression and turns over smoothly. There is no detectable play in the drive shaft, bearings, or piston connecting rod. The carb is clean and smoothIt needs a replacement engine valve cover as shown in the picture; however, the engine has run fine w/o it and undoubtedly it could use a new glo-plug and perhaps a newer muffler. Other than the one valve cover, cosmetically the engine is in good shape - no fins are damaged and there are no tooling marks that I could see. For certain you cannot beat SAITO for quality and reliability. I am selling AS-IS."

I'll bench it and check it out when it gets here.

Any one know where I can get a manual on it?

Dave

</font>