Hi ladies and gentlemen,

I have encountered a problem I may have had for some time but due to never pushing the envelope I never saw it. I have started getting into 3D flying, especially with my 450 (pro), whilst performing flight paterns that put huge stress on the tail which inturn stresses the gyro on the pro I notice it is rock solid with no problems(align GP780). When I try these same tricks with my 500 it goes all **** on me, it has a Futaba 401 with a align DS650 servo. I have been through the setup a few times and it make no difference. I have a DX6i so if anyone out there can help with setup on my TX I would really appreciate it.
I have tried upping the gain to 70% only to find the tail creeps left like a really slow piro.

cheers