help with fun world 3d please
08-18-2003 | 02:35 PM
#1
Thread Starter
Junior Member
My Feedback: (18)
Joined: Mar 2003
Posts: 18
Likes: 0
Received 0 Likes
on
0 Posts
From: stockton, CA
help with fun world 3d please
hey all ok i got a BIG prob. ok i have no idea how to run
the pull-pull on the rudder ,, SO i was thinking about just putting a carbin fiber rod all the way to the back of the plane, i'm going to be running a hitec 5945 servo in the rear, motor is a RCS 180 , if this would be ok please let me know casue like i said ( don't know how and DON"T like it ) ok well please let me know thanks jon
[email protected]
the pull-pull on the rudder ,, SO i was thinking about just putting a carbin fiber rod all the way to the back of the plane, i'm going to be running a hitec 5945 servo in the rear, motor is a RCS 180 , if this would be ok please let me know casue like i said ( don't know how and DON"T like it ) ok well please let me know thanks jon
[email protected]
08-18-2003 | 04:23 PM
#2
Senior Member
My Feedback: (1)
Joined: Dec 2001
Posts: 747
Likes: 0
Received 0 Likes
on
0 Posts
From: New Holland,
PA
help with fun world 3d please
waytoofast:
Go to this review...
Fun World 3D Review
There are some pics of the rudder pull-pull setup. The wires come out above the horiz. stab. You have to look for the holes, but they are there. They are just under the covering. Use their hardware. I have about 50 flights on the plane and there stuff is holding up just fine.
Let me know if I can help.
Jim!
Go to this review...
Fun World 3D Review
There are some pics of the rudder pull-pull setup. The wires come out above the horiz. stab. You have to look for the holes, but they are there. They are just under the covering. Use their hardware. I have about 50 flights on the plane and there stuff is holding up just fine.
Let me know if I can help.
Jim!
