CA hinges on GP G202
#1
Thread Starter
Member
Joined: Apr 2002
Posts: 30
Likes: 0
Received 0 Likes
on
0 Posts
From: Sydney Australia
I am up to hinging the control surfaces on my 1/4 scale GP G202
Who has used the CA hinges as supplied in to kit?
If you used them have you had any problems with them.
Thanks in advance
Who has used the CA hinges as supplied in to kit?
If you used them have you had any problems with them.
Thanks in advance
#5
Junior Member
Joined: Dec 2001
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
From: Rio Grande, NJ
I dont't know what I did wrong but I was running the engine on the ground without the wing on the body just running the RPM'S up and and lo and behold the rudder fell to one side breaking all but one hinge. Went and bought the large Du Bro hinges and made a piano hinge out of them let me see it fall to the side again.
#8

My Feedback: (25)
Joined: Jan 2002
Posts: 2,406
Likes: 0
Received 0 Likes
on
0 Posts
From: Cabot,
AR
You're probably lucky that's all you broke. You should never run an engine without the wing attached. The wing dampens the airflow a little, but mainly it is a vibration absorption mechanism!!!
#9
Senior Member
My Feedback: (2)
Joined: Jan 2002
Posts: 572
Likes: 0
Received 0 Likes
on
0 Posts
From: Nor Cal,
CA
It's just easier to put good quality hinges in now rather than latter.... cuz the CA hinges have a far shorter opperational life. Like everyone here I say go with the Dubro 1/4 scale hinges...... and if you really want to do it right.....Make it a piano hinge!! and aways seal the hinge line!!!!
#14
Senior Member
My Feedback: (2)
Joined: Jan 2002
Posts: 572
Likes: 0
Received 0 Likes
on
0 Posts
From: Nor Cal,
CA
I think the worse thing about the CA hinges is that say one of them breaks, then you have to sacrafice all of the hinges on that surfacej ust to fix the one......
#15
Senior Member
Joined: Mar 2002
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
From: Las Vegas, NV
Do you know that heat and cold will have shorten the life of CA hinges. They will become hard and then break at the most unusual times, and when a bird does come down it will not be the hinges that are blamed but something else.
#18
Senior Member
Joined: Jul 2002
Posts: 496
Likes: 0
Received 0 Likes
on
0 Posts
From: Land O Lakes, WI
At least a hundred flights on mine with the ca hinges that came with it and not a problem. Do make sure you seal the hinge lines with some clear ultracote. Bob




