I need the set up info for the modeltech mach racer

thanks bob

http://www.rcuniverse.com/magazine/a...article_id=745

If that's a Jett on a Mach Racer, be very careful. I had 2, one with a Magnum .52XLS with a Rossi short pipe. I got flutter on the elevons and broke the control system. My next one had an OS .50SX with a Jett tuned muffler, 9-7 prop. I used titanium pushrods and Sulliven metal control horns.

My recommendation: Do not trust the stock plastic control horns or servo arms on a high speed plane. Consider at least 4040 pushrods.

upgrades in progress

jr 517 servos out

In Hitec HS-5645MG digital w/ metal arms~4-40 hardward dubro ball link~Robart control horn.
Futaba PCM Rx
Electrodynamics switchcrharge jack.
stronger pipe mount.
weight was 3 lbs 7 oz I am adding about 2oz at the most.