I HAVE THE ECLIPS7 AND I HAVE SOME PROBLEMES WITH THE HEADING HOLD GYRO.
I CONECT THE GYRO TO THE CHANEL7 TO USE THE SWITCH FROM HEDING HOLD TO NORMAL
IN THE EPA OF CHANEL 4 I POOT THE VALUE OF 100% TOO BOTH SIDES .
THE VALUE OF NORMAL fligt condition IS 80% AND IN ST1, ST2 IS 90% (IN THE GYRO MODE )
THE VALUE OF THE MIXERS ARE INHIBIT INCLOOD THE VALUE OF THE REVMIX .
FOR NOW THE VALUE OF THE EXPO IS "0"
IF I TURN THE RUDER TOO THE LEFT OR RIGHT AND BRING BACK THE ROODER STICK TOO CENTER THE LED ON MY 401 ( FUTABA ) GYRO ARE FLASHING .(keep flashing after i leave the stick in the center)
IT SEEMS LIKE THE GYRO COOLD NOT FIND THE NUTRAL OF THE SERVO AFTER I USE THE ROODER STICK.
I TRI TO SOLV THE BROBLEM BY POOTING IN THE EXPO "-70" AND IN THE EPA OF CHANEL 4 80% ONLI WITH THAT VALUS THE GYRO FOOND THE NUTRAL AGAIN IDONT UNDERSTAND THIS THING I NEEED HELLLLPPP ( I CaNOT DOO ANI PIROET WITH THIS VALUS )
I HAVE TOO SAY THAT I DONT UNDERSTEND THE MEANING " FOR REVERSED GYRO THE SETINGS WILL BE THE OPPOSITE"
THANKS

ASI1,
You are in the Auto Gyro section.. You need to ask your question in the Heli section..
Good Luck,
Jim