I have a 75 ASP that is leaking where the fuel inlet attaches to the carb. If I close the carb off and pump fuel in the inlet it sprays out behind the needle valve. I can post a picture if that will help. I have tighten it down about as much as I can without stripping the threads. There are 2 washers, one on each side of the inlet and that is where it is leaking. Any suggestions, other than file 13.[&o][&o][&o]

"Just Engines" in England probably stocks the gaskets (washers). You could also check with Hobby People about Magnum carb parts that would be the same.


http://www.justengines.unseen.org

Are you sure something isn't cracked? It should seal pretty well without the washer even on there. A drop of blue Loctite should seal it up if there's not any damage.

I put some red gasket sealer on the washers and it seemed to correct the problem. I still think I will order a couple of washers.