Hi,

Just a quick question, i think ive just ordered some of the new Hitec HB-635HB with the wrong connection i think they have the JR/Hitec connection, but i plan to use it with a Futaba Receiver............. will they still fit and work ok ? or should i send them back or change the plugs myself if its possible ?

Thx.........

Just make sure you plug them in properly and they will work fine. Futaba has a polarity tab on their servos and extensions. If you were going to put Futaba into HiTec, you would have to trim the tabs off.

Yup Campy is right. If I remember right, JR has a corner cut off one side. Just put the cut off where the tab would go on a Futaba plug. All should be well.

Mark Shuman