Please see the attached photo.
As you can see. I ran into a silcer problem.
Now i need to remove the silencer and expoy it on.

But I put a drop of CA between the bolt/nut.

So, i managed to break the bond between the bolt and CA.
But the CA is still just sitting there, acting as a stopper!

How do I remove it. I doubt that NailPoish Remover will work.

Heat it up with a soldering iron, or just soak it in acetone. Good Luck!

Try a heat gun or maybe even a small torch. I've used that method before to remove unwanted epoxy and CA.

Hi.
Yes i thought about that.
But im scared of ANOTHER fire!
If you remember my Fire thread!

There is fuel/oil every where. I have a miniture
blowtorch. I could use that., but im scared[:-]

Don't use a torch, just an iron.