Evolution 46 NT Carb bolt!!
09-02-2007 | 11:26 AM
#1
Thread Starter
Member
Joined: Apr 2006
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
From: New Haven ,
IN
Evolution 46 NT Carb bolt!!
On the evolution 46 nt instead of a normal rc glow engine they had to go and do something stupid and put this crap on there that holds the carb on it consists of two peaces of metal both having an angle at one end, one having a slightly larger hole than the other so that the bolt can slide through one and thread into the other pulling the two angled edges together pushing one edge against the carb to hold it in place, my question is mine came loose in flight and i lost the one side that the bolt threads into does anyone know of anything that would substitute because everywhere around here doesnt have it and horizon wont have them out till late september?? anything that would work would be greatly appreciated!!!
09-02-2007 | 01:08 PM
#2
RE: Evolution 46 NT Carb bolt!!
No guarantee of in stock but........
http://www.wholesaletrains.com/Detail.asp?ID=200303457
http://www.wholesaletrains.com/Detail.asp?ID=200303457
09-03-2007 | 06:44 AM
#4
Senior Member
My Feedback: (7)
RE: Evolution 46 NT Carb bolt!!
ORIGINAL: Superchipmunk91
On the evolution 46 nt instead of a normal rc glow engine they had to go and do something stupid and put this crap on there that holds the carb on it consists of two peaces of metal both having an angle at one end, one having a slightly larger hole than the other so that the bolt can slide through one and thread into the other pulling the two angled edges together pushing one edge against the carb to hold it in place, my question is mine came loose in flight and i lost the one side that the bolt threads into does anyone know of anything that would substitute because everywhere around here doesnt have it and horizon wont have them out till late september?? anything that would work would be greatly appreciated!!!
On the evolution 46 nt instead of a normal rc glow engine they had to go and do something stupid and put this crap on there that holds the carb on it consists of two peaces of metal both having an angle at one end, one having a slightly larger hole than the other so that the bolt can slide through one and thread into the other pulling the two angled edges together pushing one edge against the carb to hold it in place, my question is mine came loose in flight and i lost the one side that the bolt threads into does anyone know of anything that would substitute because everywhere around here doesnt have it and horizon wont have them out till late september?? anything that would work would be greatly appreciated!!!
Send me a private message with mailing address and I'll take the parts off my motor and mail them to you tomorrow free of charge. No need to send me replacements as they are so cheap I'll just add them to my next Horizon order. bob
