Hey guys a guy gave me half a dozen old servos they are airtronics 94631s what would i use for a radio to get them to work or does it matter whar rx they work with?

Some of the old airtronics servos are wired different from everything else

We need a breakdown if these are the old or new type

The new type are compatible with most any radio

http://www.hobbypeople.net/part/RP0115.asp

http://www.hobbypeople.net/gallery/479473.asp

These servos are wired like most all others and are compatible with most any radio system you may have particularly the Hitec, Futaba, JR, and Spektrum variety

You'll have to deal with the wiring if they have older black connectors on them. Look at the attached diagram.

Ken

ok the guy says that they where used with a airtronics 92765 rx are there other servos that can be used with this rx or can i change the ends on them? they are kind big they dont fit in to the wing servo tray on the sea hawk that i am slowly rebuilding for this spring i would take a pic but cant find what the wife did with my cam ...she clean my work bench while i was away at boat school now she cleans LOL [:@]

The standard servos of different brands vary slightly in size.
the new design ARFs are coming out with servo pockets for the new mini hi torq servos

Your key to the Airtronics servos on hand would be to look at the connectors.

If the red wire is in the center they will fit most any radio

You might need some of these if they are the old connector. http://www.hobbypeople.net/gallery/479400.asp