HiTec HS-325HB Servos on Trainer 60
#1
Member
Thread Starter
My Feedback: (3)
Join Date: Jun 2010
Location: Walnut CA
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
HiTec HS-325HB Servos on Trainer 60
I bought some Hi Tec HS-325HB servos.
The spec.says Applications: Aircraft 20 - 40.
Are they actually powerful enough on a Trainer 60?
It says Torgue: 51 oz. in at 6V, 41.6 oz-in at 4.8V
Thanks
#4
Member
Thread Starter
My Feedback: (3)
Join Date: Jun 2010
Location: Walnut CA
Posts: 40
Likes: 0
Received 0 Likes
on
0 Posts
RE: HiTec HS-325HB Servos on Trainer 60
Thanks.
I was trying to install the servo onto the wing.
however, the servo is too tall and one end of it won't completely goes into the hole.
In other words, the wing is not thick enough.
You know, the wing is thicker on one side and goes thinner to the side close to Aile.
So, I could only screw down one side of the servo.
do I need to get some sort of servo mount tray?
or it is just a wrong size servo for my wing.
thanks again.
#5
My Feedback: (16)
RE: HiTec HS-325HB Servos on Trainer 60
The Trainer 60 should take standard size servos like the Hitec 325 without any adjustments other than a little trimming?
Are you sure there's not another piece of plywood spacer that goes there to raise the mount up higher?
Some of these planes, the servo pockets are a little small and you have to trim the pocket out a little for the servo to fit into the hole?
Are you sure there's not another piece of plywood spacer that goes there to raise the mount up higher?
Some of these planes, the servo pockets are a little small and you have to trim the pocket out a little for the servo to fit into the hole?