just wanting to see you has upgraded funfactors and what has been done .
i have a mt2 and so far have done uni shaft ,alu brake seat ,alu steer link , etc . waiting for new era suspension arms and roll bar . going to attempt .18 engine and steel gears with hardened diff . one way front diff to finish off .
i have nothing but fun with my truck hope everyone else does too. [8D]

i have the same hopups on my rally, except for the roll bar and alloy arms. i have also fitted a OS18 cvrx, this engine uses the original engine mounts, you just need to space the pinions out slightly. also fit some xtra bearing in each hub, the ones u use for the diff will fit on the shoulder of the stub axle and make the wheels much more secure.

hope that helps

hey poor judgement its truck 78 . just through this on here trying to generate some more dicussion about cen ff cars . and there ability to kick butt . funny people either love cen products or fully hate them . most who bag em out never had one and are only going off one or two bad experiences from new useres with little experience .

yeah got the bearings on order also the ones for the bell crank steering . 4 thinkthey are 73901 5x8x2.5 . size .

u mentioned steel gears in ur first post - i guess u mean the diff? as i havent seen any steel spurs...did i miss something?

yeah the bevel gear in the diff . wish there were metal spur gears . mine have stood up ok and only just starting to wear . got to always check mesh . found best way is put engine as hard up to gears and still allow to spin nicely .rear edge of smaller gear (2nd) is wearing slighly more may be paralel runing problem .