nemesis drill start
#1
Member
Thread Starter
Join Date: Jan 2006
Location: Spring Hill,
FL
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
nemesis drill start
What do I need to change my nemesis to a drill type starter? I see a kit with a roto-starter included for about $50, but I'd just as soon use one of my batt powered drills and save some money. Anyone have part numbers, and a good place to order from?
#2
Junior Member
Join Date: Dec 2005
Location: Rio Rancho,
NM
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
RE: nemesis drill start
I think if you go with the tiger drive S680 it works better. Friend has the roto start back plate and needs a 18 volt to turn it, but it works awesome. I might go with the tiger drive myself for my LE Genesis, which is the same engine
#3
Senior Member
My Feedback: (2)
Join Date: Feb 2005
Location: Milford,
CT
Posts: 524
Likes: 0
Received 0 Likes
on
0 Posts
RE: nemesis drill start
ihave the tiger drive it broke on me the first time, because for the genesis /nemesis you need to press the bearing into the housing farther so that it gets better grip on the 5.0hp motors crankshaft. I believe there is a warning on their website and/or might be a pamphlet that comes with the tiger drive now telling you to make sure and do this, Anyways the first one broke and tigerdrive replaced it free ( it took them forever to send it though) And once i did what they stated i never had a problem again. I use a 7.2 volt drill to start the truck ( its a bit slow turning over but its enough to get it started fairly quickly)
#4
Senior Member
My Feedback: (4)
Join Date: Feb 2005
Location: Ellensburg, WA
Posts: 1,598
Likes: 0
Received 0 Likes
on
0 Posts
RE: nemesis drill start
Just buy the roto-start back plate. Mount it so that it's in the lower right. Got a piece of cold roll, drill and mount a cross pin to fit in the drive and your set. Remember to have your drill set in the right direction. Total should be less than $20
#8
Member
Join Date: Jan 2006
Location: mi,
FL
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
RE: nemesis drill start
yes, posted above just mounted tiger drive on my nemy. I had to trim the 2 corners. 1 by the exhaust pie and the 1 by the bottom frame plate. yes it is at an angle drill rod out by the gas tank.
roto start back plate part # G70359
roto start back plate part # G70359
#9
Member
Thread Starter
Join Date: Jan 2006
Location: Spring Hill,
FL
Posts: 63
Likes: 0
Received 0 Likes
on
0 Posts
RE: nemesis drill start
Thanks for the info Cmepoo. Decided to go with the tiger drive myself. Mounted it just like you said you did. Made it easy. Nice set-up. Thanks again.