Servos.......
03-20-2007 | 05:59 AM
#1
Thread Starter
Member
Joined: Sep 2005
Posts: 55
Likes: 0
Received 0 Likes
on
0 Posts
From: York County,
VA
Servos.......
I just went to hobbytown last night and bought a brand new O.S. .18 CV-RX for my MT2. But I would like to get a better radio sytem for it, does anybody know what hitec or futaba servos are compatible? I am clueless when it comes to that stuff 
03-21-2007 | 10:50 AM
#3
Senior Member
RE: Servos.......
I run the hitech 645mg servos in my mt2.. I switched to the airtronics mx3 radio that cen offered as an upgrade... their stock radio is either the impact or skyon am.. I believe they are made by airtronics as well.. (I could be wrong)... I had to modify..(shave) off the ends of the plugs to fit... otherwise... direct replacement... futaba and hitech should fit as well...
03-22-2007 | 01:10 PM
#4
Senior Member
Joined: Nov 2005
Posts: 132
Likes: 0
Received 0 Likes
on
0 Posts
From: Arcadia, CA
RE: Servos.......
Be careful of the polarity of the plugs before you just plug the servo into the RX. Futaba radio gear is generally different from Airtronics/Sanwa/Jr/Hitec for the wiring. The positve and negative leads are swapped for the Futaba versus that of the Universal or (Hitec/JR/Air) plugs. Also if you do install Futaba Servos and have the correct polarity, you will have to shave a little plastic off the Futaba servo plug to be able to plug the servo into the RX.
Hope this helps.
Hope this helps.
