cx2 rx channel problem
08-30-2008 | 11:45 AM
#1
Thread Starter
Junior Member
Joined: Feb 2007
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
From: Singapore, SINGAPORE
cx2 rx channel problem
Hi guys,
I got a esky Douphin fuslage meant for a lama4 and squeeze it into a cx2.
The fuslage came with a LED and after plugging it into the spektrum ar6100e "Gear" Channel, the cx2 glitch like crazy when throttle.
I checked the wiring, everything is in order. Only after unplugging the LED connector everything is fine.
Is this right ? or do i have a faulty rx ? I read somewhere the cx2 suppose to be a 5ch tx. is there any mixing done on the tx ?
Thanks
I got a esky Douphin fuslage meant for a lama4 and squeeze it into a cx2.
The fuslage came with a LED and after plugging it into the spektrum ar6100e "Gear" Channel, the cx2 glitch like crazy when throttle.
I checked the wiring, everything is in order. Only after unplugging the LED connector everything is fine.
Is this right ? or do i have a faulty rx ? I read somewhere the cx2 suppose to be a 5ch tx. is there any mixing done on the tx ?
Thanks
08-31-2008 | 04:12 AM
#3
Thread Starter
Junior Member
Joined: Feb 2007
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
From: Singapore, SINGAPORE
RE: cx2 rx channel problem
ORIGINAL: evdreamer
Are you sure you didn't plug it into the signal pin on the gear channel and only in the 5V and ground pins?
Nick
Are you sure you didn't plug it into the signal pin on the gear channel and only in the 5V and ground pins?
Nick
