Will this work?
03-19-2009 | 07:31 PM
#1
Thread Starter
Senior Member
Joined: May 2007
Posts: 1,106
Likes: 0
Received 0 Likes
on
0 Posts
From: Boca Raton,
FL
Will this work?
Will this work for the tail on Blade 400?
Spektrum DSP75 Prog. Digital Sub-Micro Servo
Specs
Size Category: Minis and Micros
Type: Digital
Torque: 19.0 oz/in @ 4.8v
Speed: .11 sec/60° @ 4.8v
Dimensions (WxLxH): .90 x .45 x .94 in (23 x 12 x 24mm)
Weight: .26 oz (7.5 g)
Bushing Or Bearing: Bushing
Motor Type: Coreless
Connector Type: Universal
Gear Type: Nylon
http://www.spektrumrc.com/Products/D...rodID=SPMDSP75
I replaced all the others with Hitec 65's and used all the stocks for the tail, on my last stock servo.
Spektrum DSP75 Prog. Digital Sub-Micro Servo
Specs
Size Category: Minis and Micros
Type: Digital
Torque: 19.0 oz/in @ 4.8v
Speed: .11 sec/60° @ 4.8v
Dimensions (WxLxH): .90 x .45 x .94 in (23 x 12 x 24mm)
Weight: .26 oz (7.5 g)
Bushing Or Bearing: Bushing
Motor Type: Coreless
Connector Type: Universal
Gear Type: Nylon
http://www.spektrumrc.com/Products/D...rodID=SPMDSP75
I replaced all the others with Hitec 65's and used all the stocks for the tail, on my last stock servo.
03-19-2009 | 08:41 PM
#2
Senior Member
Joined: Dec 2008
Posts: 866
Likes: 0
Received 0 Likes
on
0 Posts
From: shelby twp.,
MI
RE: Will this work?
thats pretty much whats on it now, one say`s spektrum and the other says e-flite. but its the same servo
dont waste your money.
you need something in the range like .05 to .09 sec @4.8v
look at the jr. ds290g, futaba 9257 9650.
gws as one people are useing too
dont waste your money.
you need something in the range like .05 to .09 sec @4.8v
look at the jr. ds290g, futaba 9257 9650.
gws as one people are useing too
