Need help with CC160 hv
10-23-2011, 04:45 PM
#1
Thread Starter
My Feedback: (58)
Join Date: Dec 2009
Location: peterborough, ON, CANADA
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
Need help with CC160 hv
Need some help with my new CC 160Hv esc
As soon as I connect my 10s or 12s power,the esc beeps the appropriate times and that's it.
Example,10 beeps to recognize the 10 cell and then silence.
The esc is flashing red constantly.
What am I doing wrong?
I've tried adjusting the throttle.
Thanks for your input.
Doug
As soon as I connect my 10s or 12s power,the esc beeps the appropriate times and that's it.
Example,10 beeps to recognize the 10 cell and then silence.
The esc is flashing red constantly.
What am I doing wrong?
I've tried adjusting the throttle.
Thanks for your input.
Doug
10-23-2011, 06:00 PM
#3
Thread Starter
My Feedback: (58)
Join Date: Dec 2009
Location: peterborough, ON, CANADA
Posts: 92
Likes: 0
Received 0 Likes
on
0 Posts
RE: Need help with CC160 hv
Thanks,did that, I am running twin fans on my F4,one works one doesn't,even when I disconnect the esc that works (right side) same result.
Also hooked the good one (esc) to the left fan/motor it works fine, so I know the fans are good.
Also hooked the good one (esc) to the left fan/motor it works fine, so I know the fans are good.
10-29-2011, 02:06 AM
#4
Member
Join Date: Dec 2009
Location: Owen Sound, ON, CANADA
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
RE: Need help with CC160 hv
You seem to be trying to run 2 EDF fans from one ESC. You can't do that. they each ahve to have their own ESC. The TWOEsc's then get whyed to the RX. You know that you require a separate Bec/Rx battery to run the RX here. The CC has no Bec built in. The flashing sounds like the Rx is telling you its not getting a signal thru the esc. FWIWflytreetimes .
