Hi All,

I was wondering, with all the outrunners around, how close are they to the same distance from back of mount (rear mounting) to back of spinner backplate (1)? And is there a standard bolt pattern for these rear mounts (3)?

Pletty
Rimfire
Axi(s)
Hacker
Hyperion
Eflight
Cyclone

anymore I'm missing?

After I drew the motor, what about the same for the front (2)?

Jason the AXI/F3A
back of motor to back of spinner backplate is 71 MM
spinner back plate to front of motor and this tapers so closest to prop shaft is 9mm and 15 mm is the outside of case.
the only demension different on the AXI 5320/28 would be the lenght and it is 61 mm
Steve Maxwell

Jason,

Plett Extra 30 Evo that dim is 67mm

Link to installation drawing on Plett website: http://www.plettenberg-motoren.com/U...0evo/Masse.htm

Malcolm

the cyclone f3a

Weight 19.4 oz 550G
Diameter 2.6 Inch 65mm
Length 3.3 Inch 83mm
Shaft 8m


marcelo

The E-flite Power 160 is 72mm from back of mount to the front of the hub and 9mm from front of hub to motor. This is when mounted at the rear with front prop hub per your drawing.

Per the spec:

Weight: 650g (23.0oz)
Overall Diameter: 63mm (2.50 in)
Shaft Diameter: 8mm (.30 in)
Overall Length: 64mm (2.50 in)

Thanks guys for helping with this. I made the drawing a bit easier to understand what I was looking for, I hope. I also added the Cyclone motor

How about 3 for the mounting bolts Jas.

AXI 5330/F3A #1= 71mm #2= 9mm and #3 = 31mm
AXI 5320/28 #1= 61mm #2= 9mm and #3 = 31mm

The E-flite Power 160 i

1) 72mm from back of mount to the front of the hub
2) 9mm from front of hub to motor
3) 52 mm between mounting holes on motor mount