Piccolo Fun tail problem.
10-24-2004 | 08:37 PM
#1
Thread Starter
Junior Member
Joined: Sep 2004
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
From: fairfield, CT
Piccolo Fun tail problem.
Hello all,
I recently got a P-Fun and it's a real bute'. However, at times the tail does this thing where it just swings its' tail round. I can't seem to find a reason for it happening.
It doesn't seem to matter whether the battery is new/fresh or old/used. I'll have it perfectly set up, have a good flight, (30sec./1min.,) with no events, land, rest and lift-off again and sometimes the tail just goes off on its' own, usually after a few seconds of flight.
It seems to happen once a battery at or near the beginning? I'm still monitoring it to see if there is a pattern.
This just seems to be too random, you don't know when it will happen and it always seems to happen for no good reason whatsoever.
????????????????Any thoughts?
I recently got a P-Fun and it's a real bute'. However, at times the tail does this thing where it just swings its' tail round. I can't seem to find a reason for it happening.
It doesn't seem to matter whether the battery is new/fresh or old/used. I'll have it perfectly set up, have a good flight, (30sec./1min.,) with no events, land, rest and lift-off again and sometimes the tail just goes off on its' own, usually after a few seconds of flight.
It seems to happen once a battery at or near the beginning? I'm still monitoring it to see if there is a pattern.
This just seems to be too random, you don't know when it will happen and it always seems to happen for no good reason whatsoever.
????????????????Any thoughts?
11-04-2004 | 07:34 AM
#2
Junior Member
Joined: Nov 2004
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
From: kfar saba, ISRAEL
RE: Piccolo Fun tail problem.
have the same problem with my feda dragonfly.
i'm using seprate electronics (a difrent speed controler for the main motor and another for the tail).
a GWS PG03 Piezo Gyro
and a gws reciver.
a 8.4 v batt
i tried evrything - i replaced the tail motor,the gyro and the reciver -so as the motor controlers and the problem remain.
i'm using seprate electronics (a difrent speed controler for the main motor and another for the tail).
a GWS PG03 Piezo Gyro
and a gws reciver.
a 8.4 v batt
i tried evrything - i replaced the tail motor,the gyro and the reciver -so as the motor controlers and the problem remain.
