Share your videos of EDF jets in action.
The following users liked this post:
gonzalobures (08-06-2020)
08-14-2020 | 11:24 PM
#33
Joined: Nov 2010
Posts: 16
Likes: 0
Received 0 Likes
on
0 Posts
From: , AUSTRIA
Scratchbuild PAK TA, 157 inches 53 pounds
Maiden flight of my New PAK TA 
Flight number 3 and 4 to test if the plane could get off from a grass field, test the landing flaps, gather some telemetry data and do some simple aerobatic up to 4G to test the strength of the plane.
Regards, Josef
Flight number 3 and 4 to test if the plane could get off from a grass field, test the landing flaps, gather some telemetry data and do some simple aerobatic up to 4G to test the strength of the plane.
Regards, Josef
10-21-2020 | 10:47 PM
#37
Joined: Nov 2010
Posts: 1,708
Likes: 0
Received 81 Likes
on
77 Posts
From: Coffs Harbour NSW, AUSTRALIA
It takes a while to sort it out, few short flight trials after re-set of flight controls from El. assist Elevons to standard Ail/El. function.
(EDFHydroPropJet EL. Trials)
(EDF Hydro final trim test runs)
Bit of a handful at first.
All good after 8 runs, even damaging the model while it flipped over after 6th. landing roll out!
Bit of a handful at first.
All good after 8 runs, even damaging the model while it flipped over after 6th. landing roll out!
