FINISH PROCEDURE FOR DEPRON JETS ??
#1
Thread Starter
Join Date: Aug 2007
Location: Kaysville, UT
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
FINISH PROCEDURE FOR DEPRON JETS ??
Greetings . I am building depron jets and have no idea how to finish them. I have been flying for 34 years but have never fooled with fomies. Can someone tell me the prep procedures , what paint or covering to use and how it is applied. Thanks much Denny
#2
Senior Member
My Feedback: (6)
Join Date: Jun 2004
Location: bklyn,
NY
Posts: 122
Likes: 0
Received 0 Likes
on
0 Posts
RE: FINISH PROCEDURE FOR DEPRON JETS ??
denny,
i just lighty paint them with water based spray paints and go throw em in the air!!! after all.... foamies are for flyin. . balsa is for scale contests!!
i just lighty paint them with water based spray paints and go throw em in the air!!! after all.... foamies are for flyin. . balsa is for scale contests!!
#3
My Feedback: (10)
RE: FINISH PROCEDURE FOR DEPRON JETS ??
Krylon short cuts is one of the better rattlecan paints for foam. Krylon H20 runs really easily and is a bit thick by the time the color looks good.
If you have an airbrush and dont mind a little mixing, go to wally world, in the houshold/craft area they have a myriad of colors in waterbased acrylic for around a buck a color. They are excellent paints for our foamies and clean up great.
If you have an airbrush and dont mind a little mixing, go to wally world, in the houshold/craft area they have a myriad of colors in waterbased acrylic for around a buck a color. They are excellent paints for our foamies and clean up great.