slow-stick spec
09-23-2003 | 11:36 PM
#1
Thread Starter
Member
Joined: Apr 2003
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
From: Orlando, FL
slow-stick spec
does anyone know where I can find specifications for the slow-stick ?
Specifically, I'm after the amount of dihedral (in inches etc) and the width of the aluminium fuselage
thanks
Digsy
Specifically, I'm after the amount of dihedral (in inches etc) and the width of the aluminium fuselage
thanks
Digsy
09-24-2003 | 02:52 PM
#2
Senior Member
Joined: Dec 2002
Posts: 2,198
Likes: 0
Received 0 Likes
on
0 Posts
From: Chattanooga,
TN
RE: slow-stick spec
Just measured mine for you - the fuselage is 10mm square section (11/32" in confusing US units), and, as built, mine has 17cm (6.5") OVERALL dihedral measured to the tip of the trailing edge (i.e. if the wing was mounted in position, the two trailing edge tips would each be 8.5cm (3.25") above the horizontal).
Hope this helps,
Cheers, Phil
Hope this helps,
Cheers, Phil
09-24-2003 | 04:43 PM
#3
Senior Member
Joined: Sep 2003
Posts: 374
Likes: 0
Received 0 Likes
on
0 Posts
From: Waynesburg,
PA
RE: slow-stick spec
Here ya go...if ya have anymore GWS questions on specs. 
[link=http://www.gws.com.tw/english/product/airfly/airplane.htm]GWS website[/link]
Brian
[link=http://www.gws.com.tw/english/product/airfly/airplane.htm]GWS website[/link]
Brian
