ESC modification
01-06-2011 | 03:53 PM
#1
Thread Starter
Junior Member
My Feedback: (1)
Joined: Jan 2011
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
From: pittsville, WI
ESC modification
To anyone who knows. I am new to electric power. I was told that by cutingthe red, black or white wire on an ESC with BEC, this would disabble the BEC. If so which wire. I would assume its not the black signal wire. that leaves 2.
01-07-2011 | 01:46 PM
#4
My Feedback: (4)
Joined: Jul 2004
Posts: 7,906
Likes: 0
Received 0 Likes
on
0 Posts
From: Lakeland,
FL
RE: ESC modification
Don't cut the wire. Just lift the tab on the plug and slip the wire out. Piece of heat shrink over the terminal and tape it to the harness.
That way down the line you can use the esc in something else that you don't need a stand alone bec in.
That way down the line you can use the esc in something else that you don't need a stand alone bec in.
