hey everyone
i am seriosly looking at a CH ignitions module with syncro spark for christams[>:]
but first i want to contact them and ask a few questions.
can anyone tell me who they are on RCU? or their email?

thanks guys
shaun

http://www.ch-ignitions.com/ Lots of information. Terry has always been informative and helpful. Service is a priority. I believe Terry goes by tkg .

We here, wacha need?

thanks for the heads up mikenlapaz

i sent you an email tkg

shaun

TKG, Would you tell us what the part number is for the Allegro Hall sensor ?

i ordered a CHXL igntion but i have one question about the 'synchro-spark' in them.
if i set the hal sensor @ 28 BTDC what will the maximum retard be???
from what i have gathered the first time it fires will be at 28 BTDC and when the engine runs it will slow down to 2 BTDC.
is that correct???

shaun

That must have been a hard question...no answer yet! Capt,n

Shaun sold the ignition to me last summer, but I can't give the answer

If you turn the numbers around it should be correct.

The CHXL has 24 degrees of timing movement. So if your set at 28 the the engine is at 4 deg BTDC at startup.

TKG, is the RCEXCEL a 24 degree'r also ????

Not sure, but a CHXL is the aout the same unit, if not the same as a RCEXCEL. Most likely the same advance. Capt,n