RE: 21cc Echo timing?
 

frenchie79: That 24cc Stihl you are working on sounds like its going to be a good one. Please give us the data & photos as you go. thanks Capt,n;)

RE: 21cc Echo timing?
 

Buck & Captain-You both seem to know about these engines and i'm getting off the post topic. I'm going to start a new post on Stihl engines since i'll be posting on several. Please join it. "Don't forget Stihl"

RE: 21cc Echo timing?
 

I buy my magnets at radio shack.There in the parts drawers.

RE: 21cc Echo timing?
 

Radio Shack-thanks. We have that store in my small town. I'll check it out.

RE: 21cc Echo timing?
 

http://www.rcuniverse.com/forum/m_7837600/tm.htm

RE: 21cc Echo timing?
 

Hey!
I just modified my echo 21cc engine for my YAK but I can't find a prop hub does anyone know where I can get one thanks!
Mike

RE: 21cc Echo timing?
 

Hello!

I have an ECHO 21cc that I'm working on now for a YAK but I can't find where to get a prop hub for it. Does anyone have any idea

Thanks!
Mike

RE: 21cc Echo timing?
 

I recently inquired about the same parts and was told to look at [link=http://www.fpengines.com/html/13.htm]First Place Engines 1.3 Conversion[/link].

I contacted Kurt and this is the response I got:

Matt

Here is a list of the parts and prices:

1.3 pitts muffler with bolts $75.00
1.3 Fonolic carb mount with bolts $18.00
1.3 Prop Hub with set screws $30.00
1.3 Carb with bolts $30.00
1.3 Carb Gasket $3.00
1.3 Prop Bolt $5.00
1.3 Aluminum prop washer $6.00

Thank You
Kurt Roth
(724)588-9559

RE: 21cc Echo timing?
 

Make a wanted post, many guys could probably spin one for you at a minimum charge. Is the engine like this one.

RE: 21cc Echo timing?
 

Try topcat01 on E_AY.

Real nice guy.
hub 17.00

RE: 21cc Echo timing?
 

Hello!
Yes that engine is the same.
Mike

RE: 21cc Echo timing?
 

Hey Matt!
Did you ever order the parts and did they work.
thanks!
Mike

RE: 21cc Echo timing?
 

As stated earlier,i buy mine from topcat01,you can also check:
ch-ignitions
rcignitions
wackerengines
indiannatinygasengines
my buddy-j.romine who sells here on rcu and does conversions
My self,i have a 6 bolt hub for an echo laying around,i also have a lathe if ya need somthing
The thread size is 8x1.25.
Ill see if i can find anymore off hand.I know the G23-26 is 1.2 but i dont know if there 1.25.Ask Ralph at rcignitions.