I have the Futaba 12 FG. I have 2 aileron servos plugged in to diffrent channelsand mixed togather in a mix to funtion togather. I want to adjust each aileron throw seperatly but I went into AFR and it looks like it does them togather? I went into the mix and went into the second page and it does not look right either? Again want to fine tune each surface on its own in the radio so I can get ther correct throw on both surfaces,please help as I have tried what seems to be everything?
Thanks

If you want to have two aileron servos operating off of the same channel, and want full control over the AFR, then you will have to use an auxiliary channel, set the control and trim to J1 and T1, and then rename it, if you wish. That works very nicely.