Setting Switch Endpoints
04-19-2017 | 09:10 AM
#1
Thread Starter
My Feedback: (1)
Joined: Aug 2005
Posts: 98
Likes: 0
Received 0 Likes
on
0 Posts
From: Omaha,
NE
Setting Switch Endpoints
Using switch SG on an MZ18, two position switch, for ignition. PowerBox spark switch wants 0% and 100% for on and off. Switch travels from -100 to +100. How do i adjust switch to go between 0 and 100?
Thanks
Jack
Thanks
Jack
04-20-2017 | 07:17 AM
#2
My Feedback: (11)
You're getting different ways of saying the same thing confused. The powerbox wants a good range for the "one end, other end" movement. They're calling one end "0%" and the other end, "100%". For Futaba, "0%" is the center of the channel's movement, so one end is 100% in that direction and the other end is 100% in that direction.
Just use the 100% endpoints (or more) and you'll be OK.
Just use the 100% endpoints (or more) and you'll be OK.
