Need Help in programming the Super 8
07-19-2004 | 12:53 PM
#1
Thread Starter
Senior Member
Joined: Dec 2002
Posts: 184
Likes: 0
Received 0 Likes
on
0 Posts
From: Third Rock From the Sun,
Need Help in programming the Super 8
Need help on dual elevator servo pgm. What channels do you use ,what mix do you use and if you use ch. 6 7 or 8 how do you disable the rotory knob?
07-20-2004 | 08:32 AM
#2
Joined: Jan 2003
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
From: Champaign, IL
RE: Need Help in programming the Super 8
Hi Pile-O-Wood,
Please check out our FAQ's on the 8U at:
http://www.futaba-rc.com/faq/faq-8u.html
I am sure these will answer all of your questions.
I hope you find this information helpful. You can also reach our Futaba support technical team at 217-398-8970, or via fax at 217-398-7721.
Sincerely,
Krysta
Lead Futaba Customer Service and Programming Technician
Please check out our FAQ's on the 8U at:
http://www.futaba-rc.com/faq/faq-8u.html
I am sure these will answer all of your questions.
I hope you find this information helpful. You can also reach our Futaba support technical team at 217-398-8970, or via fax at 217-398-7721.
Sincerely,
Krysta
Lead Futaba Customer Service and Programming Technician
