9C flap switch assignment
03-06-2005 | 09:27 PM
#1
Thread Starter
Member
Joined: Nov 2004
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
From: Meadville,
PA
9C flap switch assignment
I would like to use switch C for throttle cut and idle down. However, when programed in flaperon per the manual 'C' drops the flaps when in the down position. how do I reassign the switch?
03-08-2005 | 04:57 PM
#2
My Feedback: (11)
RE: 9C flap switch assignment
If you use the built-in flaperon function, you cannot change the switch assignment. It's fixed in the software. To get around that, you'd have to do the flaperon mixing by using Pmix's. You could then select any switch/slider to activate the flaps.
