6EXAS Elevator Pmix Question
#1
Junior Member
Thread Starter
My Feedback: (6)
Join Date: Aug 2002
Location: Harrisburg,
PA
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
6EXAS Elevator Pmix Question
I am having trouble with setting up my dual servo elevator control using pmix. I have a brand new 6EXAS. The master throws are perfect, but the slave is giving me 50% the amount of throw as the master (only in one direction), not being able to move beyond center. I've tried to make sure everything else is turned off, set the slave to 100%, and recentered my slave to match the master servo channel...Any suggestions?
Thanks in advance!
-Dave
Thanks in advance!
-Dave