TM-7 2.4Gig Module Area Select
01-03-2008 | 08:01 PM
#1
Thread Starter
Member
Joined: Jul 2003
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
From: GalstonNSW, AUSTRALIA
TM-7 2.4Gig Module Area Select
Can you tell me what the "Area Select" switch on the module does? In the manual it says:
This doesn't say what the switch does
Kerry
Normally please set at "GENERAL". In case of in France, please set at "FRANCE"
Kerry
01-04-2008 | 10:02 AM
#4
Joined: Jan 2003
Posts: 3,796
Likes: 0
Received 0 Likes
on
0 Posts
From: Champaign, IL
RE: TM-7 2.4Gig Module Area Select
France can only use 2.4GHz at lower power output than the US, so this switch is used if you are located in France as a legal requirement of their country.
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
Sincerely,
Krysta
Product Development & Support Specialist
Futaba Service Center USA
ORIGINAL: rconabudget
Can you tell me what the "Area Select" switch on the module does? In the manual it says:
This doesn't say what the switch does
Kerry
Can you tell me what the "Area Select" switch on the module does? In the manual it says:
Normally please set at "GENERAL". In case of in France, please set at "FRANCE"
Kerry
