Hi

Im setting up the elevons on my hotspot with 4 servos.
Im using the method stated here: http://www.futaba-rc.com/faq/faq-9c-q510.html , but I cant seem to get all 4 servos to trim when trying to trim the aileron part. Only the 2 outboard servos move when i trim aileron. If i trim elevetor, then all 4 servos move.

Anyone run into this ?
I guess it would be ok to only trim the outboard elevons ??





SJ.

When you activated the Pmix, did you turn TRIM on? That would let the mixer know that the slave channel gets trim information from the master.

Thanks Bax, but I found another solution.

http://www.rcuniverse.com/showthread...932&forumid=26


SJ..