setting up choke
01-25-2005 | 08:08 PM
#1
Thread Starter
Joined: Jun 2004
Posts: 116
Likes: 0
Received 0 Likes
on
0 Posts
From: Montague,
CA
setting up choke
I have a Hanger ( P51 1.50) that I have been working on and have installed an RCS 180 with front carburetor. But I have been stumped by how to install and connect the choke linkages.
I have been considering the use of a bell crank with one end connected to the choke and the other just a rod coming through the bottom of the cowl. I am using a JR6102 (6ch)
Has any one used this engine / plane if so how did it connect?
I have been considering the use of a bell crank with one end connected to the choke and the other just a rod coming through the bottom of the cowl. I am using a JR6102 (6ch)
Has any one used this engine / plane if so how did it connect?
01-27-2005 | 01:27 PM
#2
My Feedback: (63)
Joined: Jul 2003
Posts: 1,199
Likes: 0
Received 0 Likes
on
0 Posts
From: Bethlehem, GA
RE: setting up choke
ORIGINAL: tpc3
I have a Hanger ( P51 1.50) that I have been working on and have installed an RCS 180 with front carburetor. But I have been stumped by how to install and connect the choke linkages.
I have been considering the use of a bell crank with one end connected to the choke and the other just a rod coming through the bottom of the cowl. I am using a JR6102 (6ch)
Has any one used this engine / plane if so how did it connect?
I have a Hanger ( P51 1.50) that I have been working on and have installed an RCS 180 with front carburetor. But I have been stumped by how to install and connect the choke linkages.
I have been considering the use of a bell crank with one end connected to the choke and the other just a rod coming through the bottom of the cowl. I am using a JR6102 (6ch)
Has any one used this engine / plane if so how did it connect?
