Why does it rip???
#2
not sure why but I can tell you when
All of mine between my 12" prop on a fun fly to a 28" prop on the Edge does it when adding throttle to stop a tailslide during a torque roll or hover.
Kinda like revving up an engine while pulling the plane backwards on the ground. Never tried it but it might recreat it.
Maybe some physics guru or engineer could better explain it.

All of mine between my 12" prop on a fun fly to a 28" prop on the Edge does it when adding throttle to stop a tailslide during a torque roll or hover.
Kinda like revving up an engine while pulling the plane backwards on the ground. Never tried it but it might recreat it.
Maybe some physics guru or engineer could better explain it.
#4

My Feedback: (17)
Joined: Aug 2002
Posts: 784
Likes: 0
Received 0 Likes
on
0 Posts
From: Chesapeake, VA
Excessive speed (RPM's) is one reason, another reason is prop tip flutter.
I had a very dramatic (and cool) demonstration of this on my 100cc engine. I put a 24/12 3 blader on it to try and when applying full power on the ground, you could actually watch the prop tips deflect about an inch forwards!
Prop flutter needless to say is not healthy for anything involved or effecient at all, but it sure sounds cool
I had a very dramatic (and cool) demonstration of this on my 100cc engine. I put a 24/12 3 blader on it to try and when applying full power on the ground, you could actually watch the prop tips deflect about an inch forwards!
Prop flutter needless to say is not healthy for anything involved or effecient at all, but it sure sounds cool
#5
Member
Joined: Aug 2002
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
From: Trondheim, NORWAY
Hei Polle,
Noen saker skal man bare undre paa. Hold deg under 0.6 mach saa gaar det godt.
Kommer du og din kompis til Chivas Cup (http://home.no.net/mfk1983/) siste helgen i august?
mvh
Kato
Noen saker skal man bare undre paa. Hold deg under 0.6 mach saa gaar det godt.
Kommer du og din kompis til Chivas Cup (http://home.no.net/mfk1983/) siste helgen i august?
mvh
Kato
#6
Thread Starter
Member
Joined: Jul 2002
Posts: 66
Likes: 0
Received 0 Likes
on
0 Posts
From: ballerup, DENMARK
Hej Kato.
Jeg fik opklaret mysteriet om at de ripper et andet sted her på RC/U
Det er først i dag jeg ser dit indlæg her.........
Vi har snakket lidt om at tage en tur til Norge i løbet af året, men jeg kan ikke rigtig finde rundt i de forskellige træf i har :stupid:
Venlig hilsen
Poul
ps. Mon de andre undrer sig over vikingesproget
Jeg fik opklaret mysteriet om at de ripper et andet sted her på RC/U
Det er først i dag jeg ser dit indlæg her.........
Vi har snakket lidt om at tage en tur til Norge i løbet af året, men jeg kan ikke rigtig finde rundt i de forskellige træf i har :stupid:
Venlig hilsen
Poul
ps. Mon de andre undrer sig over vikingesproget



