Ryobi 31cc ?
08-29-2010 | 05:32 PM
#1
Thread Starter
Junior Member
My Feedback: (7)
Joined: Jan 2003
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
From: Northern Kentucky
Ryobi 31cc ?
I have a Ryobi 31cc engine mounted on my GP Giant Stik. When I advance the throttle forward the engine will hesitate and then throttle up but only at about 50% power with throttle full open. I have a pitts style muffler mounted on the engine, when muffler is left off I have no problem with the throttle going to full power. No hesitation and l00% full power with no muffler.
Can anyone out there help me solve this problem?
Can anyone out there help me solve this problem?
08-29-2010 | 06:05 PM
#2
Joined: Dec 2001
Posts: 1,946
Likes: 0
Received 0 Likes
on
0 Posts
From: Summerfield,
NC
RE: Ryobi 31cc ?
ORIGINAL: Dave172
I have a Ryobi 31cc engine mounted on my GP Giant Stik. When I advance the throttle forward the engine will hesitate and then throttle up but only at about 50% power with throttle full open. I have a pitts style muffler mounted on the engine, when muffler is left off I have no problem with the throttle going to full power. No hesitation and l00% full power with no muffler.
Can anyone out there help me solve this problem?
I have a Ryobi 31cc engine mounted on my GP Giant Stik. When I advance the throttle forward the engine will hesitate and then throttle up but only at about 50% power with throttle full open. I have a pitts style muffler mounted on the engine, when muffler is left off I have no problem with the throttle going to full power. No hesitation and l00% full power with no muffler.
Can anyone out there help me solve this problem?
09-01-2010 | 05:46 PM
#6
Thread Starter
Junior Member
My Feedback: (7)
Joined: Jan 2003
Posts: 24
Likes: 0
Received 0 Likes
on
0 Posts
From: Northern Kentucky
RE: Ryobi 31cc ?
I took off the engine back plate, made a new gasket and bolted the engine back to my mount. Took the plastic limiter caps off the need valves, adjusted the low end needle valve. It now runs great.
