back plates
09-26-2011 | 11:40 AM
#3
Thread Starter
Senior Member
Joined: Oct 2008
Posts: 194
Likes: 0
Received 0 Likes
on
0 Posts
From: Corbin,
KY
RE: back plates
ORIGINAL: fordman1
A 40 SR doesn't have a back plate as it's a rear induction engine. Do you mean the 40FSR??? I have both but I'd have to check.
A 40 SR doesn't have a back plate as it's a rear induction engine. Do you mean the 40FSR??? I have both but I'd have to check.
Thanks
wattmeter
09-26-2011 | 03:06 PM
#5
Thread Starter
Senior Member
Joined: Oct 2008
Posts: 194
Likes: 0
Received 0 Likes
on
0 Posts
From: Corbin,
KY
RE: back plates
ORIGINAL: fordman1
Just checked. A 40 FX will not fit a 40FSR. I may have a spare backplate. I'll look in my box of sapre parts.
Just checked. A 40 FX will not fit a 40FSR. I may have a spare backplate. I'll look in my box of sapre parts.
]
09-26-2011 | 03:25 PM
#6
My Feedback: (2)
Joined: Feb 2002
Posts: 2,995
Received 0 Likes
on
0 Posts
From: Hervey Bay Queensland, AUSTRALIA
RE: back plates
Has anyone tried to see if the backplate off a 40FP or 35FP will fit the 40 FSR?
I have both, and could check, if there is any interest. I might try it just for my own curiousity.
I have both, and could check, if there is any interest. I might try it just for my own curiousity.
09-27-2011 | 05:49 AM
#13
Joined: Apr 2009
Posts: 267
Likes: 0
Received 0 Likes
on
0 Posts
From: Oberschoena, GERMANY
RE: back plates
...yes and not only the conrod. The Bigend from the conrod can snap out to the backside of the engine and for sure not only the conrod gets destroyed if this happens. Don't try this at home...
Kind Regards,
Holm
Kind Regards,
Holm
09-27-2011 | 01:37 PM
#14
Banned
Joined: Jun 2011
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
From: , CA
RE: back plates
Nope, won't fit.
Just checked, I got one. Send me a couple bucks for shipping and it's yours. PM me your address and I'll get it out tomorrow. I'm going out of town Friday so get me your address qjickly.
ORIGINAL: d_bodary
I have a backplate for a 40-46SF part#25407000
I am not sure if it will fit your engine or not though.
Maybe someone can chime in
I have a backplate for a 40-46SF part#25407000
I am not sure if it will fit your engine or not though.
Maybe someone can chime in
09-30-2011 | 03:14 AM
#16
Joined: Jun 2008
Posts: 345
Likes: 0
Received 0 Likes
on
0 Posts
From: Christchurch, NEW ZEALAND
RE: back plates
ORIGINAL: controlliner
A four stroke may run without a backplate, but the con rod would be in peril if you did.
A four stroke may run without a backplate, but the con rod would be in peril if you did.
Dave H
