Irvine 120 Engine
06-04-2006 | 11:22 PM
#3
Thread Starter
My Feedback: (235)
Joined: Mar 2002
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
From: Kennewick,
WA
RE: Irvine 120 Engine
Thanks for the response.
It's got a few more hours in it so I haven't yet disassembled it. Just trying to get ready for when it really needs it.
S'pose hard chromeing the liner would work (if I can't find a new one)??
It's got a few more hours in it so I haven't yet disassembled it. Just trying to get ready for when it really needs it.
S'pose hard chromeing the liner would work (if I can't find a new one)??
06-04-2006 | 11:37 PM
#4
My Feedback: (16)
RE: Irvine 120 Engine
Yes, hard chroming will work fine.
But it may only need a little 400 wet or dry sand paper scuffing or a brake cylinder hone run through it.
Most worn model engines I've been around would have no wear ridge at the top of the sleeve. Worst case was usually a deep scratch somewhere on the sleeve.
I'm assuming it is a ringed engine. You can get a new ring from Frank Bowman. You can send the whole engine to him and he can do it all if you want.
Frank Bowman
1211 N. Allen
Farmington, NM. 87401
505-327-0696 (6 pm to 9pm MST weekdays)
Email: [email protected]
But it may only need a little 400 wet or dry sand paper scuffing or a brake cylinder hone run through it.
Most worn model engines I've been around would have no wear ridge at the top of the sleeve. Worst case was usually a deep scratch somewhere on the sleeve.
I'm assuming it is a ringed engine. You can get a new ring from Frank Bowman. You can send the whole engine to him and he can do it all if you want.
Frank Bowman
1211 N. Allen
Farmington, NM. 87401
505-327-0696 (6 pm to 9pm MST weekdays)
Email: [email protected]
06-05-2006 | 04:54 PM
#5
My Feedback: (2)
Joined: Feb 2002
Posts: 2,995
Received 0 Likes
on
0 Posts
From: Hervey Bay Queensland, AUSTRALIA
RE: Irvine 120 Engine
groundlooper
Did you try Paul at JustEngines?
I have had success with his UK based business in obtaining parts for a re-build on my long out of production
Irvine .20 diesel.
link:
www.justengines.co.uk
Send Paul an email, he usually replies with 24 hours.
You can deal with him with confidence, his service is 1st class in my experience.
Parts will be sent to the US, no problem there.
fiery
Did you try Paul at JustEngines?
I have had success with his UK based business in obtaining parts for a re-build on my long out of production
Irvine .20 diesel.
link:
www.justengines.co.uk
Send Paul an email, he usually replies with 24 hours.
You can deal with him with confidence, his service is 1st class in my experience.
Parts will be sent to the US, no problem there.
fiery
