PROGRAMING ECLIPSE 7
03-25-2012 | 03:16 PM
#1
Thread Starter
Junior Member
My Feedback: (4)
Joined: Nov 2002
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
From: Alta Loma,
CA
PROGRAMING ECLIPSE 7
I am trying to program the flaps function into the three position switch in such a way that each position can add a given percentage of flaps. I have tried the land function and the flaperon function but don't much care for the VR 1 operation since the potentiometer starts in the middle and can go either way with no center "feel" when operating by touch/feel. Any help would be greatly appreciated.
Thanks,
Ron H
03-25-2012 | 05:21 PM
#2
Senior Member
RE: PROGRAMING ECLIPSE 7
<span style="font-size: smaller">ORIGINAL: mainbeam225 I am trying to program the flaps function into the three position switch in such a way that each position can add a given percentage of flaps. I have tried the land function and the flaperon function but don't much care for the VR 1 operation since the potentiometer starts in the middle and can go either way with no center "feel" when operating by touch/feel. Any help would be greatly appreciated. Thanks, Ron H</span>
Hitec Eclipse & Eclipse 7 Pro
- All Manuals, Addenda, Quick Setup, CCPM and Additional Programming FAQ
If original Eclipse 7 with rotary pot on top, there were two types.
The later version had an extension and the earlier ones can be drilled and tapped to take
a 4/40 bolt which then acts as a lever and easy to align centre with a small marker.
Alan T.
Alan's Hobby, Model & RC FAQ Web Links
03-25-2012 | 08:12 PM
#3
Thread Starter
Junior Member
My Feedback: (4)
Joined: Nov 2002
Posts: 19
Likes: 0
Received 0 Likes
on
0 Posts
From: Alta Loma,
CA
RE: PROGRAMING ECLIPSE 7
Thanks Alan I appreciate the quick return and the info. I assume that it impossible to program the flight mode switch to this purpose. I like the idea of making a lever out of a knob and will do that.
Thanks again,
Ron H
Thanks again,
Ron H
