Programming question
08-11-2007 | 06:29 PM
#1
Thread Starter
Senior Member
My Feedback: (1)
Joined: Oct 2002
Posts: 655
Likes: 0
Received 0 Likes
on
0 Posts
From: Somewhere
Programming question
I have a Futaba 9C and a Hitec programmer and plan to program my Hitec 5985 digital servos. My question is, do I or should I set the ATV on my transmitter to say 120% first, then program the end points and so forth of the servos? Or just leave my 9C at 100% ATV. I am planning on setting it up for 3D throws, then dialing it down for the regular flying.
08-12-2007 | 12:25 AM
#2
Senior Member
RE: Programming question
ORIGINAL: Flyboy1958 I have a Futaba 9C and a Hitec programmer and plan to program my Hitec 5985 digital servos. My question is, do I or should I set the ATV on my transmitter to say 120% first, then program the end points and so forth of the servos? Or just leave my 9C at 100% ATV. I am planning on setting it up for 3D throws, then dialing it down for the regular flying.
FAQ - Programming digital servos
Regards
Alan T.
Alan's Hobby, Model & RC FAQ Web Links
