JayC1968

My Feedback: (3)

I thought the werks clutch was the bomb then while I was doing some cleaning I took the bell off and noticed that the nut has spun itself on so tight that it is below flush and can't get a wrench on it to get it off. I was wondering what happened to my wheelies.. The shoes can't throw themselves out far enough to make good contact to the bell. I used Lock Tight and all....... I'm gonna have to cut this piece of crap off I think...

Any suggestions on how to get this thing off without cutting it ?

Longhair

Heat for the loctite.

Do you have a picture of it so I could get a better idea on how to remove it without cutting?

JayC1968

My Feedback: (3)

It's taken care of Longhair... I did not get your reply until after I took a six point deep 10mm socket and ground the walls of it to make it thin enough to to fit into the the the face to reach the nut. Worked like a charm. Was a little tedious to get the socket right though..