NEED HELP
05-12-2010, 07:16 PM
#1
Junior Member
Thread Starter
Join Date: Apr 2010
Location: , ON, CANADA
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
NEED HELP
anyone in toronto area?
my savage needs help.... techincal terms are at a loss. Ihave a new servo for forward and reverse. they USED to work. Now it seems like a gear thingy is stripping on one side.... its not the giant gear,but the smaller one.... is that the clutch bell? I tried to see *** is was, but its all chinese to me.... "cant these things run easily"??? Im learning too much now! HELP!
my savage needs help.... techincal terms are at a loss. Ihave a new servo for forward and reverse. they USED to work. Now it seems like a gear thingy is stripping on one side.... its not the giant gear,but the smaller one.... is that the clutch bell? I tried to see *** is was, but its all chinese to me.... "cant these things run easily"??? Im learning too much now! HELP!
05-12-2010, 09:43 PM
#3
Join Date: Apr 2006
Location: Austin,
TX
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
RE: NEED HELP
Sounds like the mesh is set incorrectly or come loose.
http://www.hpieurope.com/pdfs/tutori...pur%20Gear.pdf
http://www.hpieurope.com/pdfs/tutori...pur%20Gear.pdf
05-12-2010, 10:50 PM
#4
Junior Member
Thread Starter
Join Date: Apr 2010
Location: , ON, CANADA
Posts: 22
Likes: 0
Received 0 Likes
on
0 Posts
RE: NEED HELP
thinking itis a spur gear?? the big one apparently had been upgraded to a steel one...the smaller one that it meshes with all of a sudden looks chewed up on the side closer to the big gear.. sorry no photos due to no camera
