set up redundancy
09-08-2004, 05:30 PM
#1
Senior Member
Thread Starter
Join Date: Aug 2003
Location: webster,
NY,
Posts: 136
Likes: 0
Received 0 Likes
on
0 Posts
set up redundancy
Hi Danny
Now I have Hangar 9 23lb third scale extra 300 with 2127 - one for each elevator and aileron surface, and 2 8411s for rudder. I am using 5 cell 3000mah JR receiver battery with JR charge jack switch. This set up came with the plane when I acquired it from friend - never flown. It flys great, but I am wondering re: 1- should I have more redundancy such as 2 batteries and switches (just not sure about likelihood of failure)? 2 - with five cells, do I need voltage regulator? 3 - what are your thoughts about servos 2127 adequate (one on each surface)?
Thanks for any comments.
RJM
Now I have Hangar 9 23lb third scale extra 300 with 2127 - one for each elevator and aileron surface, and 2 8411s for rudder. I am using 5 cell 3000mah JR receiver battery with JR charge jack switch. This set up came with the plane when I acquired it from friend - never flown. It flys great, but I am wondering re: 1- should I have more redundancy such as 2 batteries and switches (just not sure about likelihood of failure)? 2 - with five cells, do I need voltage regulator? 3 - what are your thoughts about servos 2127 adequate (one on each surface)?
Thanks for any comments.
RJM
