dwaynenancy

My Feedback: (62)

Danny, I have a 10X and I want to set up a switch to kill the engine by moving the throttle servo to a pre-determined set position. Is there an easy way to do this? At the present time I am not running any flight modes. Thanks.

dsnyder

Yes, set up a throttle to throttle program mix, press page, select the switch you want it on, press page twice, put the switch in the position you want it on, and enter negative percentages to take away throw in the amount desired.

felker14

My Feedback: (50)

Can you do this with the 9303? If yes. How do you do it?
Thanks

dsnyder

Yes, via the same type of set up. Enter a throttle to throttle mix, choose the switch of your choice, and enter negative percentages as desired.

mlgreene

Can this also be done for the XP8103?

Thanks
Mike

dsnyder

Yes, through the same type of mix described above.

accaptain

My Feedback: (2)

Danny, I setup my 9303 with the thro thro mix to kill the engine, but i cannot figure out how to assign it to the train button. I want some sort of spring loaded switch as opposed to the manual flip switches. Could it also be programmed onto the left side slider switch If I wanted?


Thanks,
Anthony
Accaptain

dsnyder

To put it on the button or a slider with the 9303, select that as the master "channel" of the mix.

Pile-O-Wood

Danny, I used the push button as the throttle kill switch and it acts like a push on push off switch. is there a way to make it act like a momentary switch?

dsnyder

I'm sorry to say that there is not. That is how the button works through program mixing.

accaptain

My Feedback: (2)

Thanks Danny I got it, Works good.